Solution to abnormal situation of rubber Slitter

Solution to abnormal situation of rubber Slitter

As for the solution to the abnormal situation of rubber Slitter, when the intermediate part of semi-finished product is loose, it is closely related to uneven gluing and uneven base material. At this time, the bow roll should be adjusted to support it flat, or the tension of unwinding shaft should be increased, and the cutter tube should be used to compact the base material.

When the semi-finished products produce wrinkles during winding, the pressure of the tension cylinder can be increased appropriately. Whether the tension of the coiling shaft is too tight or closely related to the glue during gluing when the coiling finished products run off: a. the tension of the tape on the coiling shaft is controlled by the tension adjusting nut. B turn the nut clockwise, tighten the tape and turn the nut counterclockwise.

Treatment of non parallel coiling shaft: a check whether the left and right sprockets are loose. B install the four take-up shafts, make horizontal adjustment on both sides of the edge stripper, correct the position, and adjust by the adjusting screws on both sides of the right internal sprocket. First adjust the left side to the required angle, and then adjust the right side to the horizontal.